Current position > Product detail
『Mass flowmeter cumulative quantity reset to zero』Related information(v cone flow meter|rotary gas meter|gallon meter|gear meter|metal tube rotameter|glass tube rotameter|nutating disk meter|transit time ultrasonic flow meter|wedge flow meter|pd meters|hydraulic flow meter|ultrasonic water flow meter|water flow meter|air flow meter|magnetic water flow meter|oxygen flow meter|gas flow meter|argon flow meter|air velocity meter|gasoline flow meter|fuel flow meter|ultrasonic water meter|digital water meter|nitrogen flow meter|solid flow meter|Oxygen tank flow meter|digital water flow meter|diesel fuel flow meter|steam flow meter|02 flow meter|compressed air flow meter|oil flow meter|liquid flow meter)
Why is it necessary to maintain a full tube state when resetting Emerson Scientific quality flow meters to zero, and what will happen if the empty tube is reset to zero ..
1， Because the principle of scientific quality and the structure of virtual contraction determine that it must be in a full tube state both when measured and when not measured. The zeroing of the full tube state (excluding bubbles, etc.) utilizes the accuracy of measurement. If the air traffic control is reset to zero, it will not affect the instantaneous flow, but it will affect the cumulative flow. Good wishes~
2. User Manual for Dexin Electronics D-600 Digital Mass Flow Meter/Controller: [5]
The core content of the user manual for Dexin Electronics D-600 Digital Mass Flow Meter/Controller is as follows:
1. Product Overview Dexin Electronics D-600 Digital Mass Flow Meter/Controller is a high-precision flow measurement and control device that uses digital signal processing technology and is suitable for gas or liquid mass flow measurement and closed-loop control scenarios. The device supports multi parameter display (such as instantaneous flow, cumulative flow, temperature, pressure, etc.) and has communication interfaces (such as RS-48
5, Modbus) to achieve remote data transmission.
2. Usage Installation requirements: The installation position should be far away from vibration sources, heat sources, and strong electromagnetic interference environments, ensuring that the pipeline is installed horizontally or vertically (depending on the direction of the fluid). When connecting pipelines, matching flanges or threaded interfaces should be used to avoid leakage. The power supply must meet the nominal voltage of
III. Common faults and solutions Fault phenomenon 1: Abnormal flow display (fluctuation or zeroing) Possible causes: sensor blockage, pipeline leakage, electromagnetic interference.
. Solution: Clean the sensor probe, check the sealing of the pipeline, shield the interference source or replace the shielded cable. Fault phenomenon 2: Unstable control output. Possible causes include improper PID parameter settings and slow response of actuators (such as valves). Solution: Adjust the PID parameters again (such as increasing the proportional coefficient or decreasing the integration time), and check the mechanical part of the actuator. Fault phenomenon 3: Communication interruption Possible causes: loose interface, protocol mismatch, address conflict. Solution: Secure the communication interface and confirm that the protocol type (such as Modbus RTU) and device address settings are correct.Fourth, maintenance and care of QR code smart ears. Daily maintenance: Regularly clea